|
12 Volts laddare inklusive 240V/DC12 adapter EK2-0902 .
Laddar 2 cells (7.4v) och 3 cells (11.1v) Li-po ackpaket med balancerar kontakt.
Laddaren är helt automatisk och känner själv av när ackpaketet är färdigladdat och visar det genom att dioden lyser grönt.
【Laddare för Li-Polymer】EK2-0851 och EK2-0902
【Specification:】
(1).Input Voltage：DC11.5~13.5V
(2).Input Current：1500 mA
(3).Single battery full voltage：4.2V±0.05V
(4).Minimum chargeable battery voltage: 1.25V (the charger will
indicate that there no battery if single cell voltage lower than this
parameter)
 |
(5).The restoration time
of defective battery: 3 MIN(If restoration still can not be finished
when overtime, indicate that the battery has been damaged)
(6).Practicable charge current: 750 mA
(7).Compatible chargeable battery: 11.1V 1000mAh；7.4V 800mAh Li-Polymer
battery
(8).Final Voltage: 8.4 ±0.1V 2 cells ; 12.6V ±0.1V 3cells
|
【Charge process:】
1.Connect the charger with power,then the red power indicator lights up,which
indicates that the power connection is normal.
2.Connect the 2 cells or 3cells Li-polymer battery with charging ports of
charger respectively or simultaneously,then the green charging indicator flashes
and it indicates the battery is on charge.
3.Green indicator stops flashes shows that the battery is full.
Charging Precautions：
1.After connecting the power,the red indicator would get light,otherwise,it
indicates that power connection goes wrong.(fig 1)
2.Green indicator would flash after connecting the battery with charger,which
indicates that battey is on charge. If green and
red indicators flash simultaneously,it indicates the error with battery,please
check whether the battery has been damaged.
If green indicator goes out and red indicator flashes,it shows that the charger
is under protection mode,please disconnect the
power for 3 seconds and switch the power on again.
3.Green indicator gets constant light after the charge finished.If the battery
has not been unplugged for a long time after charge finished,the battery would
be recharged when single battery voltage is lower than 4.15V after self
discharge.Also,this procedure will circulate,make sure the battery is in
saturated state.(fig 2)
4.Keep it away from children and take the battery out from the helicopter while
charging.
5.Fire or serious injury would be resulted in under certain conditions.so please
follow the instructions and never leave equipment unattended while charging.
6.Keep the battery charged in cool and ventilating place and be away from heat
source,flammable and explosible materials.
7.To ensure secure and quick charging,please use ESKY original chargers.
|
